Eye
III+
I
nstallation Guide
Page 23
System Configuration and Installation
RJ-45 Network Cable
It is a shielded, straight-through RJ-45 network cable. The cable will connect
the
Eye
III+
transmitter to the hub of the
LAN
for typical application.
Software
Transmitter Configuration software
A PC with Transmitter Configuration program installed (included in the CD-
ROM WRS3-AD software).
Information
Valid IP address for the transmitter.
Administrator Password for the transmitter (The default administrator
password is
“000000”.
You can change it in the reception software)
Port number for the transmitter (default value is
1024
)
Your network subnet mask
Transmitter Configuration
After you prepared all the things discussed in previous section, you should be ready to
configure the transmitter. Note that you have to do so by following the steps discussed
below before you install and use the
Eye
III+
transmitter
Transmission Unit (Transmitter)
Summary of Contents for VT3-16BA
Page 1: ...Transmission Unit Installation Guide...
Page 7: ......
