WaveStation 3000 Function and Arbitrary Waveform Generator
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: (49) 6221 82700
A
USTRALIA
& N
EW
Z
EALAND
D
ECLARATION
O
F
C
ONFORMITY
– EMC
Oscilloscope complies with the EMC provision of the Radio Communications Act per the following standards,
in accordance with requirements imposed by Australian Communication and Media Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-1:2006
and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC D
ECLARATION
O
F
C
ONFORMITY
– L
OW
V
OLTAGE
The oscilloscope meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was demonstrated
to the following specifications as listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory use
– Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and laboratory
use – Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
l
Overvoltage Category II: equipment intended to be supplied from the building wiring with a nominal
supply voltage up to 300V.
l
Measurement Category 0: measurement terminals that are not intended to be directly connected to the
MAINS supply.
l
Pollution Degree 2: operating environment where normally only dry, non-conductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must be expected. This location
is a typical office/home environment.
l
Protection Class I: grounded equipment in which protection against electric shock is achieved by basic
insulation and a connection to the protective ground conductor in the building wiring.
U.S. N
ATIONALLY
R
ECOGNIZED
A
GENCY
C
ERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to conform to the following safety
standard and bears UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and test equipment.
46
922869 Rev B
