Teledyne 4220, Installation And Operation Manual, Page: 77 / 198

4220 Flow Meter
Section 2 Programming
2-49
least one of the options will be available to you. As mentioned for
other program steps, some of these menu options may not appear
depending on the flow meter you have and choices you made
earlier in the program. D. O., pH, TEMPERATURE, and
RAINFALL all require activation in step 1 and connection of the
appropriate sensor to the flow meter. D. O. and pH will never
appear together, as only one can be used at a time. When you
have selected the condition you want, the display will advance to
the following:
For these conditions, you enter an amount which if exceeded
(GREATER THAN), or if dropped below (LESS THAN), or if
changed too quickly (RATE OF CHANGE), will activate the
alarm dialout. For RATE OF CHANGE, you enter two values:
amount and time over which change occurs . Then the
display will advance to the following:.
As described for sampler enabling previously, this step allows
you to combine conditions to produce an alarm dialout signal.
Select DONE if you don't need more than one condition to trigger
the alarm.
If you want either of two conditions to trigger an alarm, select
OR.
If you want both of two conditions to be met before signalling an
alarm, select AND. Selection of DONE will advance you to the
next display menu. Selection of OR or AND will return you to the
CONDITION menu to select the other condition.
The flow meter will then request that you enter the telephone
numbers for the remote alarms. There are five possible telephone
numbers, in decreasing order of importance. You can enter as
many as eighteen digits for each phone, so the remote targets
need not necessarily be local.
If you select DONE, the flow meter will advance to the next step.
If you select one of the NUM entries, such as NUM 1, the fol-
lowing will appear:
You can enter the phone numbers as straight seven or ten-digit
numbers, or you can use the +/– key to enter a dash. You can use
the (.) (decimal) key to enter a (,) (comma). If you want to
signal more than one remote number at a time, the numbers are
CONDITION
• GREATER THAN • • LESS THAN • • RATE OF CHANGE •
SELECT OPERATOR
• DONE • • OR • • AND •
ALARM DIALOUT NUMBERS
• DONE • • NUM 1 • • NUM 2 • • NUM 3 • • NUM 4 • • NUM 5 •
FIRST PHONE NUMBER
XXXXXXXXXXXXXXXXXX