Teleco Telair ENERGY 2510D, Use And Maintenance Manual And Instructions For Installation

Page: 9 / 44

Rev. 004
Energy 2510 D
GB
9
Place the bracket (fig. 10 ref. 3) on the 4 holes
which were previously covered by the plugs
using the same screws (fig. 10 ref. 2) and apply
the hole plugs (fig. 10 ref. 1) in the seats which
previously housed the screws.
The generator can now be located on the
previously drilled surface (fig. 8) using the
suitable vibration-damping cylinders (fig. 11 ref.
1)
4.3 Connecting the mufflers
The
Energy 2510 D
generating set comes with a
suitable exhaust pipe kit which consists of 2
mufflers, 2 exhaust pipes and their connections
Insert first the U-shaped fastening clamp code
00828 on a terminal of the 2m pipe code 00705,
let the pipe terminal through the suitable slot by a
section of at least 3 cm (fig. 12 ref. 3) into the
exhaust manifold of the generator (fig. 12 ref. 1),
then tighten the U-shaped clamp (fig. 12 ref. 2)
on the pipe-manifold connection.
Connect the 2-terminal muffler code 01760 (fig.
13 ref. 3) on the other end of the 2m pipe (fig. 13
ref. 1) observing the arrow showing the gas flow.
Tighten with a clamp D.32-35 code 01655 (fig. 13
ref. 2). Place the muffler (fig. 13 ref. 3) under the
floor of the vehicle via a suspending rubber
stopper code 02440 (fig. 13 ref. 4) and fasten the
2 mt pipe in several spots (fig. 13 ref. 1), taking
care that such fastening does not prevent the
generator from being drawn out for maintenance
purpose.
Now insert the 40 cm pipe code 03161 (fig. 13
ref. 6) in the other end of the muffler (fig. 13 ref.
3) and tighten by means of a clamp D.32-35 code
01655 (fig. 13 ref. 5).
Then insert the other end of the 40 cm pipe (fig.
14 ref. 6) in the 1-terminal muffler (fig. 14 ref. 8)
and tighten by means of a clamp D.32-35 code
01655 (fig. 14 ref. 7).