Energy 2510 B
Vers. 002
GB
8
3.3 Handling
The generating sets, complete with their packag-
ing, can be handled using common lifting and
transport vehicles.
The boxes are provided with spacers in order to
allow for the introduction of pallet truck forks.
During lifting and trans-
port, comply with accident prevention and
safety regulations. Use lifting and transport
equipment with a capacity greater than the
load to be lifted.
4 INSTALLATION
4.1 Preliminary information
Before installing the gen-
erator set, it is absolutely necessary to read
these instructions to prevent any installation
errors.
The generator must be in-
stalled so as to prevent water seeping directly
into the alternator through the air inlets; it
must therefore be protected.
Incorrect installation of generating sets can
cause irreparable damage to the equipment
and endanger the safety of users.
Should the generating sets be installed not in
compliance with the instructions in this manual,
the Manufacturer shall not be held responsible
for malfunctioning or for the safety of the generat-
ing set, by the terms of the Law Decree
2006/42/EEC. The Manufacturer shall also not be
liable for any injury or damage to people or prop-
erty.
Installation must be per-
formed by qualified and adequately trained
personnel only.
4.2 Instructions for fastening the generating
set
The ENERGY 2510 B generating sets are pro-
vided with anchoring brackets with extra vibration
dampers and a fuel filter to be fitted along the
generator feeding pipe. The brackets allow for
hanging and floor assembly.
This kind of assembly provides the following ad-
vantages: less room taken up, quick installation,
easy access for routine and unscheduled main-
tenance.
Make sure that there is enough room around the
hood of the generating set to let cooling air
through; also leave 10 cm free room between the
hood and the surrounding parts.
Should the generating set air intake be behind a
wheel of the vehicle, care should be taken to
prevent water from being sprayed into the
generating set by the wheel when raining.
Ensure that, when the door
is open, the engine sliding surface can be
taken out (Fig. 6).
4.2.1 Hanging assembly
The generator, when sticking out of the package,
is preset for hanging assembly, as shown in fig.
4.
The package also contains 4 vibration-damping
cylinders (fig. 5 ref.1) and 2 brackets for hanging
assembly (fig. 5 ref. 2).
The
vibration-damping
cylinders must imperatively be fitted as
shown in fig. 5. They must be pressed, and
NOT extended (as shown in fig. 6) by the gen-
erator weight.
