Tektronix RTX100B, Service Manual

Page: 83 / 178

Performance Verification
RTX100B ISDB-T RF Signal Generator Service Manual
3-37
Checking Option GbE performance.
Perform this procedure to check that the GbE
Gigabit Ethernet interface of RTX100B is operating properly. This test checks
that the transport stream data is correctly output from the RTX100B instrument.
1. Connect the equipment as shown in Figure 3-18.
DUT RTX100B System
Ethernet Switch
(Netgear JGS524F)
MTS400 Series System
IP Player
Version 10.1
GbE
(10/100/1000)
GbE
RJ-45
GbE (Optic, port 1)
RJ-45 (Copper, port 2)
GbE
RJ-45
GbE (Optic, port 3)
RJ-45 (Copper, port 4)
Figure 3-18: Equipment setup for Option GbE performance verification
NOTE
. Check that V10.1 or greater RTX100B software is installed.
Equipment
i d
MTS400 Series MPEG system q p
required
RJ--45 cables
Crossover RJ--45 cable
test40.TRP file
2. Power on the MTS400 Series MPEG system and allow the Windows
operating system to boot completely. Wait an additional 90 seconds for the
MPEG system to complete the Option GbE firmware loading process.