Advanced Features and Troubleshooting Manual
121
Troubleshooting Phaser 850 Printers
Turning Sys/Start Job execution on or off
You may load a startup (
Sys/Start
) file onto the printer’s internal hard disk, if installed.
The
Sys/Start
job file is similar to an
init
file: When you turn on the printer, the file
executes — providing that Sys/Start has been turned on either through a front panel
setting or with a control file downloaded to the printer.
If the
Sys/Start
file contains an error, the printer ignores the remainder of the file and may
not start up as expected.
Using the front panel
1.
When the
Ready to Print
message is displayed, use the down arrow to scroll to
Menu
;
press the
Select
button.
2.
Scroll to
Printer Configuration
; press
Select
.
3.
Scroll to
Default Printer Settings
; press
Select
.
4.
Scroll to
Advanced Printer Settings
; press
Select
.
5.
Scroll to
Sys/Start Job
. Press
Select
to change the setting to
On
.
6.
To save the new setting, scroll to
Exit
; press
Select
. The
Ready to Print
message
appears.
7.
To make the change take affect, turn the printer off and back on again.
Using utility files
Refer to
page 91
for instructions on downloading utility files. To make the change take
affect, turn the printer off and back on again.
Macintosh utility files
■
Set SysStart Job (
Turns on automatic execution of the SysStart job.)
■
No SysStart Job
(Turns off automatic execution of the SysStart job.)
PC utility files
■
SYSTART.PS
(Turns on automatic execution of the SysStart job.)
■
NOSYSTRT.PS
(Turns off automatic execution of the SysStart job.)
