Operating basics
Install the
fl
ex adapter
Use the
fl
exible tip to connect to circuit board vias on the SUT.
1.
Determine the location for the
fl
ex adapter on the circuit board.
The adapter connects to the SUT through the insulated wire provided with
the accessory kit.
2.
Use a soldering iron to melt the insulation on the wire to connect the adapter
to the SUT. (See Figure 8 on page 13.)
Use two wires to connect differential signals from the probe to the SUT.
Figure 8: Install the adapter to the SUT with the insulated wire
3.
Solder one end of the wire to the circuit board as shown. (See Figure 8.)
Install the second wire in the same manner.
4.
Install the
fl
ex adapter over the two wires and solder it in place.
5.
Connect the probe lead set to the adapter.
Install the 25° /55° holder
Use the holders to provide strain relief for the
fl
ex adapter and standard adapter
at a 25° or 55° angle.
1.
Determine if you want to use the holder with the adapters at a 25° or 55° angle
on the circuit board.
Rotate the holder to work at either angle.
2.
Position the holder so that the leads of the
fl
ex adapter or standard adapter
align to the connections on the circuit board and glue the holder into place.
(See Figure 9.)
P6910 General Purpose Probe Instruction Manual
13
Summary of Contents for P6910
