Operating basics
3.
Attach the ferrite bead as needed to improve the signal quality. (See Figure 6.)
4.
Insert the ends of the adapter onto the PCB.
5.
Solder the adapter to the PCB.
6.
Connect the probe lead set to the adapter.
Install the wide body
adapter
Use the wide body adapter to
fi
rmly hold the probe lead set in place on the PCB.
The adapters can be stacked or grouped together depending on the connection
needs.
Install the wide body adapter on the PCB after installing the wire tubing and
ferrite bead:
1.
Locate the wide body adapter in the accessory kit and trim the length
according to your needs.
2.
Trim the wire tubing to the desired length, attach the ferrite bead (if needed
to improve the signal quality), and slide the ferrite bead and tubing over the
adapter leads.
3.
Insert the ends of the adapter onto the PCB.
4.
Solder the adapter to the PCB.
5.
Identify where to place the wide body adapter on the PCB and glue it into
place. (See Figure 7 on page 12.)
Figure 7: Install the wide body adapter on the PCB
6.
Connect the probe lead set to the adapter.
12
P6910 General Purpose Probe Instruction Manual
Summary of Contents for P6910
