P5100A Adjustments
Reassemble the Probe
If you removed the metal shield to access the
fi
ne LF adjustment, it is easier to reinstall the shield with the bottom cover
removed, so begin with step 1. Otherwise, skip to step 3.
1.
Remove the bottom cover.
2.
Install the shield over the circuit board so that the shield covers the metal ends of the board housing. (See Figure 11.)
3.
Using your thumb or
fi
nger to hold the shield in place, align and seat the probe into the bottom cover, beginning at the
cable end. As you seat the probe into the connector end of the cover, pull out the spring-loaded connector to allow it to
clear the front edge of the cover and fully seat into the bottom cover.
Figure 11: Align and seat the probe into the bottom cover
4.
Verify that the metal shield is properly located. (See Figure 11.) Align the top cover onto the probe, beginning at the
cable end. As you seat the cover onto the connector end of the probe, pull out the connector to allow the cover to
clear the connector and to engage with the bottom cover.
Figure 12: Install the top cover
5.
Recheck that the probe functions properly.
End of procedure.
12
P5100A & P5150 High Voltage Probes Technical Reference
Summary of Contents for P5100A
Page 2: ......
Page 6: ......
Page 8: ...Table of Contents ii P5100A P5150 High Voltage Probes Technical Reference ...