Tektronix IsoVu TIVM Series, User Manual

Page: 32 / 82

Operating information
AutoZero
When the displayed waveform is not centered correctly (for example, due to a
small DC offset error), you might need to press the AutoZero button in the Probe
Setup menu of the oscilloscope. This might be necessary for the
fi rst time after
the self calibration operation has completed. Make sure there is no differential
signal present at the sensor tip cable.
Menu button
Press the MENU button on the controller to view the Probe Setup menu on the
oscilloscope, similar to the following
fi gure.
Figure 9: Probe Setup menu
Use the buttons on the oscilloscope to change the probe setups. Some of the
functions are the same as pushing the buttons on the controller, such as turning
clamping on or off, or setting the input ranges.
14 TIVM Series Measurement System User Manual