2-43
Configuring External Interfaces
For DVEous:
a.
Set the
DPM TYPE
to
DVEOUS.
b. Turn the
VIDEO DELAY
soft knob to select
2 FIELDS
. It is
important to set this delay correctly.
c.
Turn the
CONTROL DELAY
soft knob to select
7 FIELDS
.
d. Press the
PORT ASSIGN
button to assign PORT
A1
to the
DPM. The baud rate for Port A1 is fixed at 307 K baud.
e.
Set
CHANNEL ROUTING
for
BOTH
or
SWR IN,
depending
upon your system configuration, as described previously
under “DPM Configurations.”
f.
Reset the Control Processor in the Model 4000 Signal
Processor frame. This is done by opening the front door of
the Processor and pressing the
RESET
button located
near the top of the Control Processor module.
For Other Non-Poolable DPMs
For devices which must be set up manually:
1.
Program all other required parameters
2.
Set
EFF SEND DELAY
to 0
3.
Select
BLACK
on the Aux Bus feeding the external device
NOTE:
A delay has been introduced when changing DPM TYPE. This
delay allows a new DPM TYPE to be chosen without cycling through
intermediate DPM Types. Once the desired solution has been made, the
new DPM TYPE will be set 2 seconds later.
4.
Turn the Effects Send On and Off and look for a flash of the
wrong video (
BLACK
) as Effects Send is turned on. (The flash
appears on the M/E output for the Effects Send you selected.)
5.
Increase the
EFF SEND DELAY
one field at a time until there is
no video flash when turning on Effects Send.
Summary of Contents for Grass Valley 3000
