Tektronix DAS 9221 Option 04, User Manual

Page: 176 / 276

Appendix C: Error Messages
C–10
DAS System User Manual
Table C–1: Error Messages (Cont.)
Error Message Explanation
Sample rates faster than 5 ns invalid when
glitches enabled. You cannot use sample rates faster than 5 ns when glitches are enabled.
Select item; press Close to accept value, Esc
to cancel operation. Position cursor on the item you want to select; press the Enter key to verify your
choice.
Signal cannot be asserted or unasserted
(pulse only). This signal cannot be asserted and left asserted; it must be pulsed or not used.
Similar field in other counter event(s) also
modified. Only one counter event resource is available; if you change it, it will be changed
wherever it appears.
Similar field in other edge event(s) also
modified. Only one edge resource is available; if you change it, it will be changed wherever it
appears.
Similar field in other glitch event(s) also
modified. Only one glitch resource is available; if you change it, it will be changed wherever it
appears.
Similar field in other timer event(s) also
modified. Only one timer resource is available; if you change it, it will be changed wherever it
appears.
Similar field in other word event(s) also
modified. Only one word resource is available; if you change it, it will be changed wherever it
appears.
Software The last system power off occurred as a result of depleted system resources, such as
hard disk space or memory. This type of power-off may corrupt the hard-disk file
system but it is usually fixed at the next power on.
Some restored values changed because of
different probe status. You have restored a Deskew Values file to a module that has different probes than
those in place when the deskew values were saved. Some restored values have
therefore been changed.
Specify a breakpoint label. Enter the name of the label contained in the sequence line where you want the
breakpoint to occur.
Specify a start label. Enter the name of the label contained in the sequence line where you want the
pattern generator to start.
Specify an IRQ call label. Enter the name of the label contained in the first sequence line of the interrupt request
subroutine.
State already contains maximum number of
Clauses. This State already contains the maximum allowable number of clauses. The function
key is ignored.
Subset restored, file narrower than current
module. The file you have restored was saved to a module with more channels than your
current module.
Subset restored, file wider than current
module. The file you have restored was saved to a module with fewer channels than your
current module.
Symbol value too large for group. You entered a symbol value that is too large for the current group. Enter a smaller
value.
That key has no function. The key you pressed has no function in the current context; no action taken.
The filename must have at least one charac-
ter. Enter a minimum of one alphanumeric character as a file name.
The first character in this field cannot be a
dollar sign. Use any alphanumeric character as the first character in this field except the dollar
sign.