Tektronix DAS 9221 Option 04, User Manual

Page: 174 / 276

Appendix C: Error Messages
C–8
DAS System User Manual
Table C–1: Error Messages (Cont.)
Error Message Explanation
No more entries to delete. Key ignored. There are no more items to delete. The function key is ignored.
No more groups to delete. There are no more groups to delete. The function key is ignored.
No more pods to delete in this group. There are no more pods to delete. The function key is ignored.
No more than [n] sequences may be entered.
Key ignored. The maximum number of sequences has already been entered. The function key is
ignored.
No more than 256 conversion rules may be
entered. Key ignored. The maximum number of conversion rules has already been entered. The function key
is ignored.
No more than 8 fields may be entered in a
sequence. Key ignored. The maximum number of fields has already been entered in this sequence. The
function key is ignored.
No Power Up restore. System config does not
match. The system hardware configuration does not match the configuration in the Power Up
Setup file. The system powered on to its default settings.
No Power Up restore. Last shutdown was
abnormal. The previous shut down was not normal. The system powered on to its default
settings.
No S/W The system does not contain optional software required for the module listed with this
error.
Normal The last system shutdown occurred as a result of pushing the front-panel power
switch to the OFF position. This is the correct way to power off the logic analyzer. All
open files and inter-process communication channels will be closed.
No Start – System resources cannot be
allocated. The maximum number of clusters or modules are running.
Not converted. The width of the conversion destination must be equal to or greater than the source
width.
Not found. Search operation failed.
No valid acquisition data. The module was started, but the current acquisition was in valid. This condition can
occur after you reconfigure the module.
No valid runtime or acquisition data. No valid data has been acquired. The module never started.
No valid signal available in current context. The requested Signal Action (pulse, assert, or unassert) cannot be accepted because
of conflicts with other existing Signal Actions.
Octal input radix; use 0-7 or X. Input radix for this field is octal; enter value using 0-7 or X.
Only one Signal can be asserted or unas-
serted. Only one of the possible output signals can be asserted or unasserted. All others can
only be pulsed.
Partial Install: Unable to locate all custom
clock files. One or more (but not all) of the custom clock files are missing from custom clocking
application. Verify you have properly installed all of the application files.
Perform match-choice; press Close to accept
value, Esc to cancel operation. Type in the selection until system displays match; press the Open/Close key to verify
choice.
Please enter a channel number (0-7),
RETURN, or ESC. Enter a legal channel number, press the Return key, or press the Esc key.
Please enter a unique digit. You cannot enter the same digit more than once in the same field.
Pod 12A-7-0 Ch 76543210 removed from
Group Pg12-1. Confirms that specified channels were removed by a delete channel operation.