Tektronix AWG710, Programmer'S Manual

Page: 170 / 206

Messages and Codes
3-24
AWG710 Arbitrary Waveform Generator Programmer Manual
Table 3-14: Device errors (Cont.)
Error code Error message
2101 RealĆtime clock power
2102 Configuration record and checksum status
2103 Incorrect configuration
2104 Memory size miscompare
2105 FixedĆdisk drive initialization status
2106 Time status
2110 Front panel failure
2111 Front panel configuration
2112 Front panel communication
2113 Front panel RAM
2114 Front panel ROM
2115 Front panel A/D
2116 Front panel timer
2700 Calibration data failure
2701 Calibration data not found
2702 Calibration data checksum
2703 Calibration data invalid
3000 Run mode failure
3100 Run mode control register0 failure
3101 to 3108 Run mode control1 register bit0 to bit7
3200 Run mode control register1 failure
3201 Run mode control register1 reg0
3211 Run mode control register1 reg10
4000 Clock failure
4100 PLL lock/unlock failure
5000 Sequence memory failure
5100 Sequence memory data bus failure
5101 to 5132 Sequence memory data bus bit0 to bit31
5200 Sequence memory address bus failure
5201 to 5216 Sequence memory address bus bit0 to bit15
5300 Sequence memory chip cell failure
5301 to 5302 Sequence memory chip 0 to chip 1
5350 Sequence memory chip select failure
5351 to 5352 Sequence memory chip select 0 to select 1
6000 Waveform memory failure
6100 CH1 Waveform memory data bus failure
6101 to 6132 CH1 Waveform memory data bus bit0 to bit31