Tektronix AWG710, Programmer'S Manual

Page: 140 / 206

Data Transfer
2-110
AWG710 Arbitrary Waveform Generator Programmer Manual
<Optional Information>
::={ <Table_jump_table> | <Logic_jump_table> | <Jump_mode> |
<Jump_timing> | <Strobe> }
<Table_jump_table>
::=TABLE_JUMP<space><Jump_target(1)>,<Jump_target(2)>,
...<Jump_target(16)><CR><LF>
<Jump_target(n)>::=<NR1>
is the line number to the Table-Jump
or 0 (Off). The default is Off.
<Logic_jump_table>
::=LOGIC_JUMP<space><Jump_on/off(1)>,<Jump_on/off(2)>,
<Jump_on/off(3)>,<Jump_on/off(4)><CR><LF>
<Jump_on/off(n)>::=<NR1>
sets the Logic-Jump on or off.
<NR1> +
0 is Off, 0> is On, and <0 is Ignore. The default is Ignore.
<Jump_mode>::=JUMP_MODE<space>{ LOGIC | TABLE | SOFTWARE }
<CR><LF>
sets the jump mode. The default is
TABLE
.
<Jump_timing>::=JUMP_TIMING<space>{ SYNC | ASYNC }<CR><LF>
sets the jump mode. The default is
ASYNC
.
<Strobe>::=STROBE<space><NR1><CR><LF>
determines whether or not to
use the STROBE signal from the EVENT IN connector on the rear panel.
<NR1>
+
0 is Off,
0
0 is On. The default is Off.
Example.
This Sequence file contains two lines of sequence definitions for CH 1.
MAGIC 3002
LINES 2
"SAMPLE1.WFM","",1,0,0,0,0
"SAMPLE3.WFM","",1,0,0,0,0
TABLE_JUMP 0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0
LOGIC_JUMP -1,-1,-1,-1
JUMP_MODE TABLE
JUMP_TIMING ASYNC
STROBE 0