Tektronix AD007, User Manual

Page: 28 / 98

Getting Started
14
AD007 User Manual
Setup Procedure 1– Complete Factory Reset, Set DHCP On
If the following conditions are true, you may want to completely
reset the adapter to the factory default settings.
H The adapter has been used before and is configured with
unknown settings.
H DHCP is off and the adapter does not request an IP address from
the network.
H You are not able to access the web pages of the adapter because
the adapter is configured with unknown settings.
H You want to turn DHCP on.
To reset to the factory default settings (and turn DHCP on), do these
steps:
1. Power the AD007 adapter off.
2. Use a small tool or end of a paper clip to push in and hold the
reset button.
3. Power on the AD007 adapter and hold the reset button in until all
status indicators go to a steady amber (approximately 30 se-
conds), then release the button. The AD007 adapter automatically
reboots with the factory defaults.
4. For a complete list of the factory default settings, see Table 6 on
page 58.