Tektronix 5110, Instruction Manual

Page: 23 / 128

Section 2— 5110
SPECIFICATION AND
PERFORMANCE CHECK
SPECIFICATION
The following electrical characteristics are valid only if
the instrument has been calibrated at an ambient
temperature b20°
C and +30° C, the instrument is
operating at an ambient temperature between 0°C and
+50° C (unless otherwise noted), and each plug-in must
be operating (fully installed) in a calibrated system.
Items listed in the Performance Requirements column
of the Electrical Characteristics are verified by completing
the Performance Check in this manual. Items listed in the
Supplemental Information column are not verified in this
manual; they are either explanatory notes or performance
characteristics for which no limits are specified.
ELECTRICAL CHARACTERISTICS
Table 2-1
VERTICAL AMPLIFIER
Characteristics
Performance
Requirements
Supplemental
Information
Input Signal Amplitude
(Differential Input)
50 mV/displayed division.
Bandwidth De to at least 2 MHz
with a calibrated 5A18N.
Channel Switching
Chop Time Segment/Channel
Approximately 5 µs (»3 µs displayed,
«2 jus blanked).
Mainframe Compartment Chop
Switching Sequence Left, left, center, center...
Amplifier Channel Chop
Switching Sequence
2 channel amplifier: Ch 1, Ch 2...
4 channel amplifier; Ch 1, Ch
2, off, off,
Ch 3, Ch 4, off, off...
Alternate Frequency
Sweep rate (once each sweep).
Mainframe Compartment
Alternate Rate
One-half sweep rate (once
every two sweeps).
Amplifier Channel
Alternate Rate
One-fourth sweep rate (once
every four sweeps).
Signal Outputs (Option 7)
Left Out, Center Out
Signals
Crt-related vertical signals
Derived from interface
signal output pins
Sensitivity 0.5 V/crt div, ±3% into >100 kΩ
DC Offset
±500 mV max
Output Impedance Approximately 1 kΩ
Dynamic Range
±4 V max
Amplifier Bandwidth
>500
kHz up to ±2 V output
into C50 pF
Common Mode
Rejection
Ratio
>28 dB at 1 kHz
Noise and Chop
Breakthrough1
^100 mV at each output
connector
alf excessive noise and chop breakthrough occur, refer to Modifications To Pre-Option 7 Amplifier Plug-Ins in Section 4
Maintenance.
REV B, NOV 1978
2-1