Appendices 18-24
1A
Display CPU clock
1B-1E Reserved
1F
Set EISA Mode
If EISA non-volatile memory checksum is good,
execute EISA initialization. If not, execute ISA
tests and clear EISA mode flag.
Test EISA Configuration Memory Integrity
(checksum & communication interface).
20
Enable Slot 0
Initialize slot 0 (System Board).
21-2F
Enable Slots 1-15
Initialize slots 1 through 15.
30
Size Base and Extended
Memory
Size base memory from 256KB to 640KB and
extended memory above 1 MB.
31
Test Base and Extended
Memory
Test base memory from 256KB to 640KB and
extended memory above 1 MB using various
patterns.
NOTE: This will be skipped in ISA mode and can
be « skipped » with ESC key in EISA mode.
32
Test EISA Extended
Memory
If EISA Mode flag is set then test EISA memory
found in slots initialization.
NOTE: This will be skipped in ISA mode and can
be « skipped » with ESC key in EISA mode.
33-3B
Reserved
3C
Setup Enabled
3D
Initialize & Install
Mouse
Detect if mouse is present, initialize mouse, install
interrupt vectors.
3E
Setup Cache Controller
Initialize Cache controller.
3F
Reserved
BF
Chipset Initialization
Program chipset registers with Setup values.
40
Display virus protect disable or enable
41
Initialize Floppy Drive
& Controller
Initialize floppy disk drive controller and any
drives.
42
Initialize Hard Drive &
Controller
Initialize hard drive controller and any drives.
43
Detect & Initialize
Serial/Parallel Ports
Initialize any serial and parallel ports (also game
port).
44
Reserved
45
Detect & Initialize Math
Coprocessor
Initialize math coprocessor
46
Reserved
47
Reserved
48-4D Reserved
Summary of Contents for TEK-AT4LVG
