Teknor Industrial Computers TEK-AT4LVG, Technical Reference Manual

Page: 63 / 205

Software Setup 6-17
6.02.3 VIP-UP SECOND SCREEN
TEKNOR MICROSYSTEMS INC --- VIPer SETUP
BIOS Interrupt 13h Configuration
Flash Disk Support
Enter VIP-UP Message
VT100 & Serial Download Speed
VT100 & Serial Download Serial Port
Use Flash To Store CMOS RAM SETUP
Disabled
Not Installed
Displayed 3 seconds
19200 BPS
COM1: 3F8H
No
↑↓
to select options
PgDn(+), PgUp(-) to change an option
ESC - Quit without saving
F10 - (U)pdate Flash BIOS
There are four parts to the screen:
1. BIOS Interrupt 13h Configuration: To configure the Flash Disk in VIP-UP, proceed as
follows:
. set the ‘BIOS Interrupt 13h Configuration’ option to ‘Enabled’
. set the ‘Flash Disk Support’ option to ‘Installed’ or ‘Installed Bootable’
For more information , please refer to Section 12.01.2.
2. Enter VIP-UP message: This option allows the user to enable or disable the message
"Press CTRL-V to enter TEKNOR VIP-UP" at the top of the screen upon boot-up.
3. VT100 & Serial Download: The VT100 & Serial Download Speed option is for
selecting the desired speed for the VT100 and Download modes. The VT100 & Serial
Download Serial Port option allows the use of either COM2 or COM1 for the
VT100/Serial Download Mode hookup.
4. Use Flash To Store CMOS RAM SETUP: When this option is set to "Yes", the CMOS
RAM Setup will be restored from Flash during each power up, as long as the battery is
good. If the battery fails, the system returns to the power on default configuration.
However, when the battery is replaced, the CMOS RAM Setup is restored from Flash
(only the time and date could be lost).
Please note that modifying and saving the CMOS RAM Setup in AWARD Setup does
not change the Flash copy; to update Flash, you must return to the VIP-UP Setup and
update it while "Use Flash To Store CMOS RAM SETUP" is set to "Yes".