Teknor Industrial Computers TEK-AT4LVG, Technical Reference Manual

Page: 188 / 205

Appendices 18-25
4E Manufacturing POST
Loop or Display
Messages Reboot if Manufacturing POST Loop pin is set.
Otherwise display any messages (i.e., any non-fatal
errors that were detected during POST) and enter
Setup.
4F Security Check Ask password security (optional).
50 Write CMOS Write all CMOS values back to RAM and clear
screen.
51 Pre-boot Enable Enable parity checker.
Enable NMI, Enable Cache before boot.
52 Initialize Option ROMs Initialize any option ROMs present from C8000h
to EFFFFh.
Note: When FSCAN option is enabled, will
initialze from C8000h to F7FFFh.
53 Initialze Time Value Initialize time value in 40h: BIOS area.
60 Setup Virus Protect Setup virus protect according to Setup.
61 Set Boot Speed Set system speed for boot.
62 Setup NumLock Setup NumLock status according to Setup.
63 Boot Attempt Set low stack.
Boot via INT 19h.
B0 Spurious If interrupt occurs in protected mode.
B1 Unclaimed NMI If unmasked NMI occurs, display:
Press F1 to disable NMI, F2 reboot.
E1-EF Setup Pages E1 - Page 1, E2 - Page 2, etc.
FF Boot