Tefcold 10760, User Manual

Page: 126 / 255

1592006207 XB570L GB r1.1 26.08.2015 XB570L 7 /20
8.3 KEYBOARD WHEN A CYCLE 1,2,3,4 IS RUNNING
DISPLAY TEMPERATURES :
The upper display shows the
temperature of the thermostat probe
The
bottom display shows the
temperature of a insert probe (if
enabled) or the count down timer.
By pushing
DOWN key, the probes iP1,
iP2, iP3 and the count-down timer are
displayed in sequence.
PHASE DISPLAY : pushing the UP key
the running phase is displayed.
PH1= phase 1
PH2= phase 2
PH3= phase 3
HOW TO DISPLAY THE
REGULATION SET POINTS
By pushing the SET key the following
information are displayed in sequenze:
-
rSI = Room set point
- iSI = Stop phase set point, referred to
the insert probe
- Back to the room temperature.
HOW TO MODIFY THE ROOM SET
POINT
While rSI or iSI are displayed hold
pushed the SET key till the rSi or iSi
label starti flashing and LED near the
SET key is turned on.
Use the arrow key to modify the value
and the SET key to confirm it.
8.4 KEYBOARD WHEN THE HOLDING CYCLE IS RUNNING (H)
HOW TO DISPLAY THE HOLDING
(REGULATION) SET POINT
While the holding cycle is running, (H
icon lighted), push the SET key and the
holding set point is displayed on the
UPPER display while the
SETH label
on the bottom display
HOW TO MODIFY THE ROOM SET
POINT
While SETH is displayed hold pushed
the SET key till the SETH label starts
flashing and LED near the SET key is
turned on..
Use the arrow key to modify the value
and the SET key to confirm it.
TO CONFIRM AND EXIT : push again
the SET key