50,000 access history events
2,000 time zones
(‘hard’ time zones)
8 sub-time zones per time zone
100 holidays
Up to 128 bit card data
Two local RS-485 buses supporting the following protocols:
Tecom
OSDP v2
SALLIS by SALTO Systems
Aperio
Remote flash firmware upgradeable
Configurable end-of-line (EOL) resistor values
Up to 100 door schedules can be programmed to lock or unlock doors at
set times
Supports operator-defined door overrides for use from management
software
Each person can have a 4 to 10 digit PIN
Map up to 32 inputs and 16 relays for use with a Challenger
Plus
panel
A variety of lock types reduces the need for complex lock programming
Easy configuration of interlocking doors on the same NAC
Battery management using intelligent charging process.
Flexibility in device locations for devices (inputs/relays/readers) attached
to the NAC
Two sets of plug-in connectors (providing communications and lock
power), which require no wiring, for ease of connection to additional
boards
Each door can have up to six readers in any combination of IN or OUT
readers
Doors can be programmed to lock out a certain percentage of the times
that a valid card or PIN is presented to a reader
Supports mapping of Challenger
Plus
areas to door reader LEDs (in
supported modes)
Detailed door diagnostics from the NAC can be requested from
management software
Up to 48 macros can be programmed
Note:
Configuration via keypad is not available for the Network Access
Controller. Configuration must be done via software (CTPlus).
