Service guide
March 2001
19
5550 199 Foil
The foil is located on Guide 4,
where the sheet exits the unit.
Spare part is supplied with an
adhesive strip.
Replace foil by gently pulling it off,
cleaning guide with ethanol and
apply new foil as specified on
picture.
5551 055 Tape
5551 056 Tape
5551 055 is a common 19 mm
3M Scotch Magic Tape and is not
supplied as a spare part. 5551
056 is supplied to a pre-cut
length.
For information on installation
procedure: Please see SpinJet
Installation Guide.
5551 023 Spring
Springs are located at both roller
ends (see next picture).
Important: Do not remove or
reinstall springs by grabbing the
body of the spring, as this may
damage the preload (no visible
damage!)
Replace by gently lifting the spring
eyelet
off the stud and the shaft
end, using a pair of pliers (pointed).
Roller is retained by clearance
holes in side plates.
5550 174 Retainer 1
The press fit retainers are located
on the shafts for the one way
clutches, one on the right side (see
next picture) and two on the left
side of unit. Pull off with an M5-
screw and reinstall by gently
tapping on the end of the retainer.
5550 008 Pulley with clutch
Foil
Not to exceed
end edge
Press the adhesive
strip firmly on
Foil must
protrude 9.1
±
0.5
mm from Guide 4
5551 055
5551 056
Spring
Retainer 1
M5-hole in
center
5550 008
