Service guide
March 2001
17
Remove the 4 screws holding the
SpinJet to the clamps (picture)
and lift off the unit.
Dismount connector PCB,
disconnect harnesses and
unscrew supporting arm assembly
from side plate.
Reassemble in reverse order,
adjust and test the unit according
to section 4 and 6 of the
Installation Guide.
5550 030 Assy, harness
#12 RS232 printer
communication
Replacement follows directly from
the picture. Assure that both
SpinJet and Printer are turned off
during replacement.
2.5 Mechanical compo-
nents
5551 018 Gas spring
Replace one gas spring at a time
only. Keep SpinJet in upright
position and release retainers at
both ends. Depress gas spring
slightly with a cramp/clamp to
unload the bearing. Reassemble in
reverse order.
Caution: Depressing gas spring
requires a force of 500 Newton!
5551 019 Bumper
Support at
printer front
(2 pcs.)
Depress ends
with clamp or
vice.
Harness #12
