Service guide
March 2001
1
SpinJet 1000
Service Guide
Safety precautions
SpinJet 1000 is intended for use on the large format printer HP
DesignJet 1050C/1055CM (referred to as the printer) only. The in-
structions for installation and operation of both printer and SpinJet
1000 must be followed.
SpinJet is intended for permanent installation on the above mentioned
printer type. Normal single-sided printing is possible without removing
or tilting down the SpinJet 1000.
SpinJet 1000 is intended for operation with installed top cover and
mounted side covers.
The operator may remove the top cover during a jam removal. Only
specially trained personnel should carry out tasks for test or service
purposes, requiring operation in otherwise open and/or dismounted
condition.
The routines of inspection and replacement of wear and spare parts
must be followed. Always disconnect Power Mains before
disconnecting cables and electrical parts.
Connect SpinJet to Power Mains 100-120VAC or 200-240VAC,
50/60Hz, one phase and earth. Apply a Power Cord according to local
Voltages and Plugs. A UL Listed Power Cord rated minimum 10A,
125V is provided with SpinJet in areas where this apply.
