Page 27 sur 72
www.technomark-marking.com
TECHNOMARK
1 Allée du développement
42350 LA TALAUDIÈRE (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : [email protected]
User Guide GRAPHIX_v1.4_UK
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
Connecting the extraction system (accessory)
The extractor system should be positioned near the machine, in a zone where it does not risk to undergo shocks.
Connect one end of the 3m extraction hose to the connector on the left hand side of the machine and the other end
to the top of the extraction system. The hose is reversible.
Connect one end of the connection cable to the 8-pin connector (4) on the top of the machine's main switch and
connect the other end to the 8-pin connector behind the extraction system. The cable is reversible.
•
For continuous operation of the extraction system, set the switch at the back of the system to the 0 position.
•
To operate the extraction system controlled by marking, set the switch at the back to position 1.
In this mode, extraction is triggered automatically at the start of marking and runs for 30 seconds after marking
has finished. However, if the machine door is opened before the end of the 30 seconds, extraction stops
automatically.
The extraction system is started independently of the laser. Press the green button on the front of the
extraction system to start and stop it.
For any question on the operation of the extraction system, refer to the manufacturer's user manual.
A
A
