INSTALLATIONS
6
TL-SBC 8280 User’s Manual
Installing the CPU
The TL-SBC 8280 CPU Card supports a Socket 478 processor socket
for Intel Pentium 4 processors.
The Socket 478 processor socket comes with a lever to secure the
processor. Raise this lever to about a 90
°
angle to allow the insertion of
the processor. Place the processor into the socket by making sure the
notch on the corner of the CPU corresponds with the notch on the
inside of the socket. Once the processor has slide into the socket, return
the lever to the lock position. Refer to the figures below.
After you have installed the processor into the socket, check if the
jumpers for the CPU type and speed are correct.
NOTE: Ensure that the CPU heat sink and the CPU top surface are in
total contact to avoid CPU overheating problem that would
cause your system to hang or be unstable.
Summary of Contents for TL-SBC 8280
Page 4: ...iv TL SBC 8280 User s Manual This page is intentionally left blank ...
Page 8: ...INTRODUCTION 4 TL SBC 8280 User s Manual Board Dimensions ...
Page 14: ...INSTALLATIONS 10 TL SBC 8280 User s Manual Jumper Locations on TL SBC 8280 ...
Page 34: ...INSTALLATIONS 30 TL SBC 8280 User s Manual This page was intentionally left blank ...