INSTALLATIONS
TL-SBC 8280 User’s Manual
11
Configuring the CPU Frequency
The TL-SBC 8280 CPU card does not provide DIP switches to
configure the processor speed (CPU frequency). However, JP16 can be
used to select the Front Side Bus of the processor.
JP16: CPU Front Side Bus Select
JP16
Front Side Bus
Auto (Default)
100Mhz
133Mhz
JP2, JP3, JP4: RS232/422/485 (COM2) Selection
COM1 is fixed for RS-232 use only.
COM2 is selectable for RS232, RS-422 and RS-485.
The following table describes the jumper settings for COM2 selection.
COM2
Function
RS-232
RS-422
RS-485
Jumper
Setting
(pin closed)
JP2:
1-2
JP3:
3-5 & 4-6
JP4:
3-5 & 4-6
JP2:
3-4
JP3:
1-3 & 2-4
JP4:
1-3 & 2-4
JP2:
5-6
JP3:
1-3 & 2-4
JP4:
1-3 & 2-4
JP5: DiskOnChip Address Select
JP5
Address
D0000-D7FFF
D8000-DFFFF (default)
Summary of Contents for TL-SBC 8280
Page 4: ...iv TL SBC 8280 User s Manual This page is intentionally left blank ...
Page 8: ...INTRODUCTION 4 TL SBC 8280 User s Manual Board Dimensions ...
Page 14: ...INSTALLATIONS 10 TL SBC 8280 User s Manual Jumper Locations on TL SBC 8280 ...
Page 34: ...INSTALLATIONS 30 TL SBC 8280 User s Manual This page was intentionally left blank ...