BL-NET "Datenverwaltung" (data administration)
The BL-NET bootloader allows the transfer of functional data or operating systems to devices
in the CAN network (UVR1611, CAN monitor and CAN-I/O module) over ethernet using a
browser. In this case, additional preparation of the device for the data transfer is not neces-
sary.
Page in browser:
Selection process:
Select the node with which the data transfer is to
occur (NODE 63 is required for a new start if an
operating system update was interrupted!)
Select the transfer direction of the functional data
Select the memory position of the "Funktionsdaten"
(functional data) or "Betriebssystem" (operating
system) (the name of the data is displayed next to
the memory position number; the next row also
displays the nodes from the stored functional data)
"Transfer starten" (start the transfer)
When the transfer is finished, the status of the transfer is automatically displayed in the
browser ("erfolgreich" ("successful") or "nicht erfolgreich" ("unsuccessful")). Functional data
takes about 45s to transfer and the operating system takes about 2min 40s.
Note that, after the transfer, the controller is restarted and the node is not visible at the
BL-NET for about 20 seconds.
39