Technicolor TG672, Setup And User Manual

Page: 60 / 152

52
4 CONFIGURATION TOOLS
E-DOC-CTC-20100728-0008 v2.0
Step 2: Setup the terminal connection
Proceed as follows:
1 Open your terminal.
2 Establish a connection with the following parameters:
 Baudrate: 115200 bits per second (bps)
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
3 Make sure that your session does not interpret received data. This may cause problems when upgrading your Technicolor
Gateway via the CLI. To avoid this use the following settings:
 Emulation: ANSIW
 Telnet terminal ID: VT100
3 You are now connected to the Technicolor Gateway’s serial interface. The Technicolor Gateway now waits for you to enter
your user name and password. For more information, see
“4.3.4 Using the CLI” on page 55 .
Traces
You can also use the CLI for tracing. The following types of traces are available:

Startup traces
When the Technicolor Gateway starts up, it will send traces to the serial console allowing you to follow the boot process of
the Technicolor Gateway. To view the startup traces, restart or power on your Technicolor Gateway after setting up the
terminal connection.

Real-time traces
Press:

CTRL+Q, to start displaying the real-time traces.

CTRL+S, to stop displaying the real-time traces.
To access these setting on Microsoft HyperTerminal :
1 On the File menu, click Properties .
2 Click the Settings tab.