41
5 THE MEDIAACCESS GATEWAY WIRELESS ACCESS POINT
DMS-CTC-20120510-0000 v1.0
Blinking red
This indicates that the MediaAccess Gateway could not find your wireless client. Use the same procedure to try again
(you do not need to wait until the LED turns off).
Procedure for PIN code entry
Proceed as follows:
1
Check the label on your MediaAccess Gateway and write down the following information:
The PIN code that is printed next to the WPS logo.
The
Network Name
.
This is the default network name (SSID). If you already configured a new network name, write down the new one.
2
Go the WPS PIN code page of your wireless client.
3
Enter the PIN code,
4
Your wireless client may prompt you to select your access point. If this is the case, select the access point with the network
name that you wrote down.
Troubleshooting
If you are having trouble connecting your wireless client via WPS, this may be cause by one of the following reasons:
WPS can not be correctly executed:
Configure your wireless manually. For more information, see
“5.2 Connecting Your Wireless Client without WPS” on
.
Your wireless client is out of range:
If possible move your wireless client closer to your MediaAccess Gateway or use a wireless repeater to extend the range
of your wireless network.
Another device is interfering on the selected wireless channel:
Change the wireless channel of your MediaAccess Gateway. For more information, see
“Change the wireless channel” on
.
Do not include the hyphen when entering the PIN code. For example, if your PIN code is
1234-5678
, then enter
12345678
.
1234-5678
