Remote Control Unit (continued)
•
Automatic switching between cooling and heating
This unit automatically switches between cooling operation and heating operation according to the
difference between the room temperature and the temperature setting.
NOTE
The remote control unit sends the temperature signal to the air conditioner regularly at three
minute intervals. If the signal from the remote control unit stops for more than ten minutes
due to the loss of the remote control unit or other trouble, the air conditioner will switch to
the temperature sensor which is built into the indoor unit and control the room temperature.
In these cases, the temperature around the remote control unit may differ from the
temperature detected at the air conditioner’s position.
TIMER SELECT button
No display : The timer does not operate.
: The air conditioner stops at the set time.
: The air conditioner starts at the set time.
: The air conditioner stops and starts, or starts and stops,
at the set times every day.
MODE selector button
(AUTO)
(HEAT)
(DRY)
(COOL)
Use this button to select AUTO, HEAT, DRY or COOL mode.
: When this setting is selected, the air conditioner calculates
the difference between the thermostat setting and the room
temperature and automatically switches to the ‘‘COOL’’ or
‘‘HEAT’’ mode as appropriate.
: The air conditioner makes the room warmer.
: The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
FLAP button
Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE
To switch to the sweep function (
) when in the manual ( ) mode,
hold down the FLAP button.
FAN SPEED selector
button
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
1 HR. TIMER button
(1-HOUR OFF TIMER)
: When you press this button, regardless of whether the unit
is operating or stopping, the unit operates for one hour and
then shuts down.
ACL button
(ALL CLEAR)
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
A/C SENSOR button
When you press this button (use a small-tipped object such as a
ballpoint pen), the
mark will appear at the display. And the room
temperature is detected by the sensor which is built into the indoor
unit and the air conditioner is controlled accordingly.
NOTE
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the A/C SENSOR button to switch
to the sensor on the indoor unit.
OFF
ON
HR.
1
9
OI-858-09EG
