6-38
6. DIAG. TEST OPERATION
EO18-33006
6.3.17 Control Code Selection
6.3 PARAMETER SETTING MODE
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
2. A changed control code is stored in memory by pressing the [PAUSE] key.
3. When “AUTO”, “ESC, FL, NUL”, or “{ ,I, }” is selected, be sure to select the Non-transmissive
ribbon in the ribbon type selection operation.
4. When “MANUAL” is selected be sure to specify all the control codes 1 to 3. Failure to do
this disables selection of “MANUAL”.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key 18 times.
Select control code with the
[FEED] key or [RESTART]
key. (See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
Press the [PAUSE] key .
Continued on Section 6.3.18
Ribbon type selection.
AUTO : (Automatic selection)
ESC, LF, NUL : (Manual selection)
{ ,|, } : (Manual selection)
MANUAL : (control codes should be specified.)
When "MANUAL"
is selected, go to (A)
on the next page.
(B)
< 1
D I A G N O S T I C V
>
1 . 0 A
C O
E E S C , L F
D
, N U L
< 2
P A R A M E T E R S E T
>
