46
ENGLISH
Trouble Shooting
In case of trouble with the unit, please take the trouble to look through
this chart and see if you can solve the problem yourself before you
call your dealer or TEAC service center.
AMPLIFIER section
Output Power . . . . . . . . . . . . . . 20 W/ch (0.5 %,1 kHz)
Input Sensitivity . . . . . . . . . . . . 200 mV/22k ohms
Frequency Response . . . . . . . 20 Hz to 40,000 Hz (+1/-3dB)
TUNER Section
FM Section
Frequency Range . . . . . . . . . . 87.50 MHz to 108.00 MHz (50 kHz steps)
Signal-to-Noise Ratio . . . . . . . 65dB(Mono)
. . . . . . . 60dB(Stereo)
AM Section
Frequency Range . . . . . . . . . . 522 kHz to 1620 kHz (9 kHz steps)
Signal-to-Noise Ratio . . . . . . . 35 dB
CD PLAYER Section
Frequency Response . . . . . . . 20 Hz to 20,000 Hz(±1.5dB)
Signal-to-Noise Ratio . . . . . . . more than 85dB
Wow and Flutter . . . . . . . . . . . Unmeasurable
GENERAL
Power Requirements . . . . . . . 230 V AC, 50 Hz
Power Consumption . . . . . . . . 60 W
Dimension ( W x H x D ) . . . . . 175 x 115 x 325 mm
( 6-7/8˝ x 4-1/2 ˝ x 12-13/16 ˝ )
Weight . . . . . . . . . . . . . . . . . . . 3.6kg ( 7-15/16lb )
Standard Accessories
Remote Control Unit (RC-738) x 1
AM Loop Antenna x 1
FM Lead-type Antenna x 1
Owner's Manual x 1
Warranty Card x 1
Specifications
ENGLISH
Amplifier
No power
e
Check the connection to the AC power supply.
No sound from speakers.
e
Check the connection to the speakers.
e
Adjust the volume.
e
Select proper source.
e
Pull out the headphones’ plug from PHONES jack.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar appliances. Install the
unit apart from them, or turn them off.
Tuner
Cannot listen to any station, or signal is too weak.
e
Tune in the station properly.
e
If a TV is near the unit, put it off.
e
Install the antenna again after locating the best reception
position.
e
An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e
Press the FM MODE button.
CD Player
Cannot play.
e
Load a disc with label side up.
e
If the disc is dirty, clean the surface of the disc.
One track is played repeatedly.
e
Press the REPEAT button to cancel the repeat mode.
Sound skips.
e
Place the unit on a stable place to avoid vibration and shock.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
No program playback.
e
Press program button to display "MEMORY".
Press play button to start playing.
Remote Control Unit
Remote control doesn’t work.
e
If the batteries are exhausted, change the batteries.
e
Use remote control unit within the range (5m/15ft) and point at
the front panel.
e
Clear obstacles between the remote control unit and the main
unit.
e
If a fluorescent light is near the unit, put it off.
