1-528050-1
412-94313 Rev. A
BDA AT-65
– 01/16
Seite/Page/Página 106 / 115
ECOC: EGC0 ; LOC: AI
Error Message
Reason
Remedial Measure and
Explanation
Display Message
Emergency Stop has
been pressed and can
only be reset by the
release button.
Description
Emergency Stop
Button, see chapter
4.3.2
Press release button.
Display Message
Switch position
monitoring of safety
relay 1 and 2:
(REL 1 and REL 2)
have not switched
correctly within the
time stipulated.
Restart of the machine.
If this error occurs again, the
emergency stop relay may be
defect.
Red LED is permanently lit
+ Display Message
Only occurs in the
Production Mode and
means that a program
parameter was
chosen, which has not
been configured;
i. e. the crimping
program for this
parameter has to be
set.
Set a crimping program.
All necessary parameters/values
have to be set.
Display Failure
CAN communication of
display to control unit
was interrupted.
System has to be restarted.
Check possible sources of
interference for CAN Bus.
Check cables leading to the
display
Check the Displays.
In the event of a problem, our customer service personnel will be able to help you.
Address:
TE Connectivity Germany GmbH
a TE Connectivity Ltd. company
Schenck Technologie- und Industriepark
Landwehrstr. 55/Gebäude 83
DE-64293 Darmstadt
TE AT Customer Service Hotline: +49(0)6151-607-1518
E-Mail:
[email protected]
EMEA Field Service Hotline
EMEA Hand Tool Repair
EMEA Wear & Spare Parts
EMEA Field Service Admin & Short Term Rental Equipment
Please have the following information ready when you contact service.
+
Machine Type and Serial Number
EMRGEN.
STOP
E-STOP
FAILURE
#00x
P8
000000000
