09/2013
23
TCS TürControlSysteme AG, TCS Hotline Germany: +49 41 94/ 9 88 11 88
Subject to technical changes.
FAX: +49 41 94/ 9 88 129
Mail: [email protected]
PI_IMM2500 1A
Notes for configuring with configo
™
All functions of the basic module can be set also with the configuration software configo™.
The special functions can be programmed with th
e configuration software configo™:
– control function 10 (call triggering) on button RED, control function 1 / 2 alternating
on button YELLOW, control function 8 on button GREEN,
– internal call 3 on button RED, internal call 2 on button YELLOW, internal call 1 on
button GREEN,
– acoustic room surveillance on button RED, switching lights on button YELLOW, call
diversion with special functions module on button GREEN
(
Note: Before programming the call diversion, the AS-address of the front-door sta-
tion is to be fixed and blocked. So a call diversion to TKI and PFS can be realised.)
Select door call signalling by motion sensor
Several bright LEDs are positioned below the lens system of the motion sensor.
Select between blinking, flashing and OFF.
Set the response delay time of the motion sensor
Factory setting 12 h, can be exactly adjusted in 15 min steps,15 min … 64 h.
Configure the external push button
External push button with a switch time of at least 1 sec can be connected.
Factory setting:
In basic setting external push button open = closing contact.
Can be configured as opener
(in basic setting external push button is closed)
.
Factory setting: External push button is available, pressing the external push button
triggers the programmed function of the button RED (internal call in case of internal call
3 und room surveillance or control function 10).
With the configuration s
oftware configo™ the setup of the control function 3 and 4 can
be changed alternating by checkmark
External push button sends function 3 when
opening and function 4 when closing
.
