7
Mounting and installation
Requirements to the installation location
Harmful environmental conditions can lead to a shortened life cycle or to malfunctions.
Install and operate the display module AMI11603 not at locations with direct solar radiation or inappropriate tem-
peratures (see.
Fehler! Verweisquelle konnte nicht gefunden werden.
, page
Fehler! Textmarke nicht
definiert.
).
Connecting the lines
Internally connect the module in the front-door station
The display module AMI11603 can be connected to a built-in door loudspeaker module AMI111x0 or to modules
with a 4-pin connection cable.
First install the AMI modules into the front panel, than wire them together.
Connection to built-in door loudspeaker module AMI11100, codelock module AMI11200 and jogwheel
module AMI10410
At the built-in door loudspeaker module AMI11100:
►
Remove the terminal cover
(3)
.
►
Open the cap of the service opening
(2)
.
►
Plug the 4-pin connection cable on the service plug in the service
opening.
►
Guide the cable below the cap of the module
(1)
out to the termi-
nals.
►
Close the service opening and the terminal cover.
►
Connect the cable of the built-in door loudspeaker to the display
module.
►
Connect the codelock module AMI11200 and the jogwheel mod-
ule AMI10410.
Commissioning
The AS addresses of the bell button modules and the built-in
door loudspeaker module resp. display module have to be
identically to establish a connection.
►
Adjust the AS addresses to the same value and block
them.
Fig. 3: ZAU2004-0030 incl. AMI modules
3
2
1
AMI11100
AMI11603
AMI11200
AMI10410