TC Electronic M5000, User Manual, Page: 54 / 203

ALGORITHMS
M5ALGOIN
Rev 1.4 Page 32
INLEV off - 0.0 dB. Sets the level of the input to the program
in 0.5 dB steps. The function of the
control is to maximize dynamic range.
Please note that this control is positioned
after the input PPM meter, and will not
affect the input PPM reading, also if
using an analog input, make the analog
input adjustment in the G-LEVELS-
menu under UTIL before setting this
control. If the red overload LED still
flashes, turn down INLEV a couple of
dBs. The control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
OUTLEV off - 0.0 dB. Sets the output level of the program in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the pitch algorithm to output
maximum signal to the DA converters. It
affects the output PPM reading. There is
a separate output level control for
adjusting the analog output level in
UTIL. Set the analog input (if you use
analog input) and the INLEV
adjustments before setting OUTLEV.
The control does not affect the bypassed
signal level. Normally, you do not have
to change the factory default setting.
PAGE 2:
PITCH -12 - +12 Pitch shifting in semitones.
FINE -1200 - +1200 Pitch shifting in cents.
FB 0 - 100% The percentage of feedback. (Feedback
path includes delay, pitch and hicut).
DELAY 0 - 310 mS The delay setting. Sets the delay before
the signal is pitched.