TC Electronic M5000, User Manual, Page: 35 / 203

ALGORITHMS
M5ALGOIN
Rev 1.7 Page 13
analog input, make the analog input
adjustment in the G-LEVELS-menu
under UTIL before setting this control.
However, if the red overload LED
flashes, turn down INLEV a couple of
dB's. The control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
OUTLEV off - 0.0 dB. Sets the output level of the reverb in 0.5
dB steps. The function of this control is
to maximize dynamic range by allowing
the reverb algorithm to output maximum
signal to the DA converters. It affects the
output PPM reading. There is a separate
output level control for adjusting the
analog output level in UTIL. Set the
analog input (if you use analog input)
and the INLEV adjustments before
setting this control. The control does
not affect the bypassed signal level.
Normally, you do not have to change the
factory default setting.
DECAY 0.3 - 30.0 Sec. Reverberation decay time (fig. below).
x LOW 0.01 - 2.5 times Relative decay time multiplier for low
frequencies.
x LOMID 0.01 - 2.5 times Relative decay time multiplier for the
low-mid frequencies.
x HIGH 0.01 - 2.0 times Relative decay time multiplier for the
high frequencies.