TC Electronic M5000, User Manual, Page: 50 / 203

ALGORITHMS
M5ALGOIN
Rev 1.4 Page 28
control is to maximize dynamic range.
Please note that this control is positioned
after the input PPM meter, and will not
affect the input PPM reading, also if
using an analog input, make the analog
input adjustment in the G-LEVELS-
menu under UTIL before setting this
control. If the red overload LED still
flashes, turn down INLEV a couple of
dBs. The control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
OUTLEV off - 0.0 dB. Sets the output level of the program in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the pitch algorithm to output
maximum signal to the DA converters. It
affects the output PPM reading. There is
a separate output level control for
adjusting the analog output level in
UTIL. Set the analog input (if you use
analog input) and the INLEV
adjustments before setting OUTLEV.
This control does not affect the bypassed
signal level. Normally, you do not have
to change the factory default setting.
PAGE 2:
PITCH-1 -12 - +12 Pitch shift for channel 1 (in semitones).
FINE-1 -1200 - +1200 Pitch shift for channel 1 (in cents).
PITCH-2 -12 - +12 Pitch shift for channel 2 (in semitones).
FINE-2 -1200 - +1200 Pitch shift for channel 2 (in cents).
PAGE 3:
LEVEL-1 off - 0.0 dB The output level of channel 1.
PAN-1 50L - center - 50R Controls the position of channel 1 in the
stereo image.
LEVEL-2 off - 0.0 dB The output level of channel 2.
PAN-2 50L - center - 50R Controls the position of channel 2 in the
stereo image.
PAGE 4: