TC Electronic M5000, User Manual, Page: 39 / 203

ALGORITHMS
M5ALGOIN
Rev 1.7 Page 17
input adjustment in the G-LEVELS-
menu under UTIL before setting this
control. If the red overload LED still
flashes, turn down INLEV a couple of
dBs. The control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
OUTLEV off - 0.0 dB Sets the output level of the program in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the chorus algorithm to output
maximum signal to the DA converters. It
affects the output PPM reading. There is
a separate output level control for
adjusting the analog output level in
UTIL. Set the analog input (if you use
analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level. Normally, you do not have
to change the factory default setting.
PAGE 2:
PREDLY 0 - 490 mS* Sets the time that passes before the first
reflection of the initial pattern appears.
ATTACK 0 - 490 mS* Determines the time of the attack part in
the non-linear reflection envelope.
HOLD 10 - 500 mS* Determines the time that the gate reverb
is open until RELEASE starts to decay.
RELEASE 0 - 490 mS* Determines the time of the decay in the
non-linear reflection envelope.
* As the total non-linear reflection pattern has a fixed length, the maximum time of the above parameters will
depend on each others settings whose total cannot exceed 500 mS with standard memory.
PAGE 3:
LOCUT 20 - 2.00 KHz Low cut filter, shelving type. Provides an
overall low frequency rolloff (6 dB per
octave). Sets the cutoff frequency of the
overall low cut filter in 1/3-octave steps.
HICUT 800 - flat High cut filter, shelving type. Provides
an overall high frequency rolloff (6 dB