tbs electronics SHURCut 2500, Operator'S Manual

Page: 18 / 26

18 | P a g e
G e n e r a l D a t a H e a l t h c a r e , I n c .
Clamping the Specimen and Blade Installation
Clamping the specimen:
•
Using the C-Type Specimen Clamp
：
o
Put the specimen (4) into the clamp (1) as is
shown in the picture. Then rotate the nut (3)
clockwise to tighten the clamp. To remove
the specimen, rotate the nut
counterclockwise.
•
Using the Quick Release Clamp:
o
Pull the clamp handle (5) in the direction
showed in the picture. The clamp will open.
You can now insert the
specimen (6) into the
clamp (2). Release the handle (5), the
specimen will be clamped automatically. To
remove the specimen, repeat the same
operation.
Always clamp the specimen
first before installing the blade
to avoid injury.
Installing the blade:
•
Before installing the blade in the blade holder
clamp , make sure that the blade holder base is
secured (9). Then, choose the angle of the X-Axis
slider and secure it using
lever (10). Choose the
lateral location of the blade holder clamp and
secure it using lever (8). Finally, place the blade
in the blade holder clamp as shown by the red
arrow (11) and secure it using lever (7).
1
3
4
2
6
5
8
10
9
7
11