Taylor C709, Owner'S Manual

Page: 10 / 68

2-2
TO THE OPERATOR
Models C709 & C717
To the Operator
2
Compressor Warranty Disclaimer
The refrigeration compressor(s) on this machine are
warranted for the term stated in the Limited Warranty
section in this manual. However, due to the Montreal
Protocol and the U.S. Clean Air Act Amendments of
1990, many new refrigerants are being tested and
developed, thus seeking their way into the service
industry. Some of these new refrigerants are being
advertised as drop-in replacements for numerous
applications. It should be noted that in the event of
ordinary service to this machine's refrigeration system,
only the refrigerant specified on the affixed data label
should be used.
The unauthorized use of alternate
refrigerants will void your Taylor compressor warranty. It
is the machine owner's responsibility to make this fact
known to any technician he/she employs.
It should also be noted that Taylor does not warrant the
refrigerant used in its machines. For example, if the
refrigerant is lost during the course of ordinary service to
this machine, Taylor has no obligation to either supply or
provide replacement refrigerant either at billable or
unbillable terms. Taylor will recommend a suitable
replacement if the original refrigerant is banned,
obsoleted, or no longer available during the 5-year Taylor
warranty of the compressor.
From time-to-time Taylor may test new refrigerant
alternates. Should a new refrigerant alternate prove,
through Taylor's testing, that it would be accepted as a
drop-in replacement for this machine, then the disclaimer
in this “Compressor Warranty Disclaimer” section will not
apply to the use of the alternate refrigerant approved by
Taylor.
To find out the current status of an alternate refrigerant as
it relates to your compressor warranty, call Taylor or your
local authorized Taylor distributor. Be prepared to provide
the model/serial number of the machine in question.
Note: Continuing research results in steady
improvements; therefore, information in this Operator
Manual is subject to change without notice.
For Units Equipped with Taylor's Remote
Monitoring System
FCC / IC ID Label Placement:
• This hardware installation package includes a label
that must be placed on the unit immediately after the
installation of the IoT hardware device has been
completed.
• The label indicates the FCC ID and Industry Canada
ID for the wireless communication device. The label
must be placed on the outside surface of the
machine, in a manner that is visible and
unobstructed.
• It is recommended that this label be placed directly
adjacent to the product nameplate of this device.
FCC Compliance Statement:
• This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules.
• These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
• This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio communications.
• Operation of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference at
his own expense.
Industry Canada Statement:
• This device complies with Industry Canada license-
exempt RSS standard(s).
• Operation is subject to the following two conditions:
a. This device may not cause interference.
b. This device must accept any interference,
including interference that may cause undesired
operation of this device.