Taylor C152, Operator'S Manual

Page: 26 / 44

6-4
OPERATING PROCEDURES
085592-M
Operating Procedures
6
14. Snap the design caps over the bottom of the freezer
door spouts.
Figure 6-12
15. Install the O-ring onto the groove of the air orifice. Do
not lubricate the O-ring.
Figure 6-13
Note: Make sure the hole in the orifice is clean and not
clogged. If the hole in the air orifice is clogged, use soap
and hot water to clear. Do not enlarge the hole in the air
orifice.
16. Install the air orifice to the end of the feed tube
without the hole in the side.
Figure 6-14
17. Lay the feed tube with air orifice in the bottom of the
mix hopper.
18. Lay the feed tubes in the bottom of the mix hoppers.
19. Install the front drip tray and splash shield under the
freezer door.
Figure 6-15