Taylor C152, Operator'S Manual

Page: 30 / 44

6-8
OPERATING PROCEDURES
085592-M
Operating Procedures
6
Brush Cleaning
1. Prepare a sink with an approved cleaning solution
(examples: Kay-5
®

or Stera-Sheen
®
). Use warm
water and follow the manufacturer's
specifications
.
Important! Follow label directions. Too strong of a
solution can cause parts damage, while too weak of a
solution will not provide adequate cleaning. Make sure all
brushes provided with the machine are available for
brush cleaning.
2. Remove the cup seals from the drive shafts of the
beater assemblies.
3. From the freezer door, remove design caps, pivot
pins, draw handles, and draw valves. Remove all

O-rings.
Note: To remove O-rings, use a single-service towel to
grasp the O-ring. Apply pressure in an upward direction
until the O-ring pops out of its groove. With the other
hand, push the top of the O-ring forward; it will roll out of
the groove and can be easily removed. If more than one
O-ring needs to be removed, always remove the rear

O-ring first to allow the O-ring to slide over the forward
rings without falling into the open grooves.
4. Remove the large O-rings, front bearings, and guide
bearings from the back of the freezer door.
5. Return to the machine with a small amount of
cleaning solution. With the black bristle brush, brush
clean the rear shell bearings at the back of the
freezing cylinders.
Note: If the drip pan was filled with an excessive amount
of mix, the drive shaft O-ring of the beater assembly
should be replaced or properly lubricated.
6. Thoroughly brush clean all disassembled parts in the
cleaning solution. Make sure all lubricant and mix film
is removed. Take particular care to brush clean the
draw valve cores in the freezer door. Place all the
cleaned parts on a clean, dry surface to air dry
overnight.
7. Wipe clean all exterior surfaces of the machine.