![background image](http://html1.mh-extra.com/html/taylor/741/741_operators-manual_3771681026.webp)
6-2
OPERATING PROCEDURES
Models 702/741/772
Operating Procedures
6
.
Figure
6-3
If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater,
with the knife edge facing outward.
Note: To prevent costly damage, the hole in the
scraper blade must fit securely over the pin.
Holding the rear blade on the beater, slide the
assembly halfway into the freezing cylinder. Install
the front scraper blade over the front holding pin.
Slide the beater assembly the rest of the way into the
freezing cylinder.
Figure
6-4
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder.
4. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: front
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
5. Slide the two O-rings into the grooves on the draw
valve and lubricate them with Taylor Lube.
Figure
6-5
Lubricate the inside of the freezer door spout, top
and bottom. Insert the draw valve into the freezer
door from the
top
. It will be necessary to rotate the
draw valve to the
right
when assembling the door to
the freezer.
Figure
6-6
6. Place the freezer door gasket into the groove on the
back of the freezer door. Slide the front bearing over
the baffle rod so the flanged edge is against the door.
Do not lubricate the gasket or bearing.
11547
11549
11103
11101
Summary of Contents for 741
Page 10: ...1 6 TO THE INSTALLER Models 702 741 772 To the Installer 1...
Page 32: ...6 8 OPERATING PROCEDURES Models 702 741 772 Operating Procedures 6 Notes...
Page 38: ...9 2 PARTS REPLACEMENT SCHEDULE Models 702 741 772 Parts Replacement Schedule 9 Notes...
Page 44: ...11 4 LIMITED WARRANTY ON PARTS Models 702 741 772 Limited Warranty on Parts 11 Notes...