codic
e 02414-00100 / r
ev
. 5-2 22L18
Position the dispenser on a bench capable of
supporting the weight, even at full load.
Allow a minimum clearance of at least 15 cm all around the dispenser so as not to impede the flow of
cooling air.
Connect the dispenser to a single phase
network, using an outlet complete with earthing.
Do not use extension cables.
Q U I C K G U I D E
Installation
The instructions contained in this Guide do not substitute the User Manual. Please read the Manual carefully and correctly apply all the procedures it contains.
The instructions contained in this Guide do not substitute the User Manual. Please read the Manual carefully and correctly apply all the procedures it contains.
ENG
WARNING
!
Check for the presence of any
leakage by removing the purpose-designed tray.
In case they are present, make sure the scraper
coupling seal is properly installed and not worn.
If it is, replace with an original spare part from
the manufacturer.
At each washing, ensure
seal piston valve.
Check the dispenser and make sure there are
not product leaks from the tap assembly seal.
If you notice a leak, check first and foremost
that the components have been assembled
correctly, then make sure the seal is not worn
or faulty, in which case replace it with an
original spare part from the manufacturer.
Maintenance
daily
wheekly
monthly
Eliminate any dust that has built up on the
condenser filter situated at the rear of the
machine.
15
16
17
1
2
3
