Taylor 358, Operator'S Manual

Page: 30 / 38

8-2
TROUBLESHOOTING GUIDE
Models 358 and 359
Troubleshooting Guide
8
8. Excessive mix leakage
in the driveshaft drip
pan.
a. Missing or worn driveshaft seal on
driveshaft.
a. Install or replace regularly. 6-1
b. The driveshaft seal is installed
inside out.
b. Install the seal properly. 6-1
c. Lack of lubrication. c. Lubricate properly. 6-1
d. Worn rear shell bearing. d. Contact a Taylor service technician to
replace the rear shell bearing.
- -
9. Excessive mix leakage
from the door spout.
a. Missing or worn draw valve
O-rings.
a. Install or replace regularly. 6-2
b. Inadequate lubrication of draw
valve O-rings.
b. Lubricate properly. 6-2
c. Wrong type of lubricant is being
used (example: petroleum-based
lubricant).
c. Use proper lubricant (example: Taylor
Lube).
6-1
10.No freezer operation
after placing the
machine in Auto.
a. The machine is unplugged. a. Plug into wall receptacle. - -
b. There is no mix in the mix hopper. b. Fill the mix hopper with mix. 6-5
c. Circuit breaker tripped to OFF or
blown fuse.
c. Turn breaker to ON position or
replace fuse.
- -
d. Beater motor out on reset. d. Reset the freezer. 5-2
11.Product is not feeding
into the freezing
cylinder.
a. Inadequate level of mix in the mix
hopper.
a. Fill the mix hopper with mix. 6-5
b. Mix inlet hole frozen up. b. Mix hopper temperature needs
adjustment. Contact a Taylor service
technician.
- -
Problem Probable Cause Remedy
Page
Ref.