6
OPERATING PROCEDURES
Operating Procedures
Model 0738
6-5
6.
Insert the driven gear on the pin; check that
the upper face of the gear is flush with the rim
of the pump body. Lightly lubricate the flat
faces of both gears.
7.
Install the pump cover on the pump body
studs.
Note: The pump cover holes have
different diameters to prevent incorrect
assembly.
Install the handscrews and tighten them
equally to make sure the pump is closed.
Note: Do not lubricate the graduated holes.
8.
Slide the regulator O-ring into the groove on
the liquid regulator and lubricate.
9.
Insert the regulator spring into the liquid
regulator seat. Insert the pump valve into the
spring so the larger part is out of the spring.
10.
Insert the liquid regulator into the hole located
on the bottom of the pump cover, aligning the
notch with the retaining pin. Rotate to lock in
place.
Summary of Contents for 0738
